Alarm SAF RMBE Series Manuel d'instructions télécharger pdf (Page 4)

Section 1

Introduction

The RMMV series of rackmount power supplies provides either 24 or 28 VAC for powering CCTV or

similar low voltage AC operable equipment AND 12 and 24VDC for powering access control or

similar DC equipment.

The units are intended for mounting within a standard nineteen inch electronics rack and may not be

exposed to rain, moisture, or temperature conditions outside the stated range of operation.

All units:

 Are single phase, cord connected, and operate on 120VAC @ 60 Hz.

 Have separate internal AC and DC supplies, each with its own group of outputs

 Have 8 DC outputs and 16 AC outputs

 DC outputs are selectable for 12VDC or 24VDC by zone

 AC outputs are selectable for 24VAC or 28VAC by zone to overcome long wire runs

 Provide a green LED visual indicator for presence of output voltage by zone on the front panel.

 Utilize a combination master ON/OFF switch and circuit breaker to control primary power.

 Feature a plug-in cord with computer-style power entry module.

 Feature screw-secured plug-in field wiring terminal strips.

 Provide frontal access for changing fuses or zone output voltage configuration.

 Utilize easily-obtainable ATM style 3A fuses unless PTC protected.

 Provide enhanced surge and transient protection.

 Are standard rack mount at 19" width and 3.5" (2RU) height, depth is 10".

RMMV Series Installation Instructions

7/13/2009, 10:26:56 AM

52-391 Rev A.02

Page 4 of 20

AlarmSaf

65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com

1 2 3 4 5 6 7 8 9 ... 19 20

Pas de commentaire

Alarm SAF RMBE Series Manuel d'instructions Page 4