Alarm SAF RMBE Series Manuel d'instructions télécharger pdf (Page 14)

5.2.2.1.3 AC FLT

This LED illuminates when the AC input voltage falls below approximately 85% of the

nominal input voltage setting.

5.2.2.1.4 COM FLT

This LED illuminates on any of the following conditions:

 High or Low Battery Voltage

 High or Low Output Voltage

 Missing / Damaged Battery

 Earth Ground Fault

 Fault received on ABC connector

5.2.2.1.5 GND FLT

This LED illuminates whenever there is an Earth Ground Fault between either positive or

negative rail of the power supply output.

5.2.2.2 Indicators on the SPS4 Board

The SPS4 contains three visual indicators

Lights when the SPS4 detects a fault conditionYellowFaultFLT (D6)

Lights when DC voltage is present on the outputGreenDC OutputDC OUT (D8)

Lights when DC voltage is present on the inputGreenDC InputDC IN (D7)

ConditionsColorDescriptionLED

5.2.2.2.1 DC IN

This LED illuminates whenever there is DC voltage present on the input of the SPS4.

5.2.2.2.2 DC OUT

This LED illuminates when DC voltage is available at the outputs of the SPS4.

5.2.2.2.3 FLT

This LED illuminates if the DC output of the SPS4 goes either high or low or if the output

fuse (F1) ruptures.

RMMV Series Installation Instructions

7/13/2009, 10:26:56 AM

52-391 Rev A.02

Page 14 of 20

AlarmSaf

65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Alarm SAF RMBE Series Manuel d'instructions Page 14