Alarm SAF RMBE Series Manuel d'instructions télécharger pdf (Page 10)

4.2 Wiring

4.2.1 Wire Routing

All wiring must be installed in accordance with NFPA70 [NEC760] and all local code

requirements.

Power Limited wiring requires that power limited and nonpower limited wiring remain physically

separated. All power limited circuits must remain at least one quarter inch (¼") away from any

nonpower limited circuit wiring.

4.2.2 AC Power Connection

Before using the distributed power outputs, the unit must be connected to the main electrical

power. Use the supplied cord set to plug the unit into the rack power strip and verify that the AC

indicator light built into the main ON/OFF switch on the rear panel and the Green LED's on the

front panel are illuminated when the unit is turned on.

Shut off the electrical power to the location of the unit, and then complete the general

installation.

4.2.3 Field Wiring

Locate the field terminal wiring blocks on the back panel of the unit and remove the terminal

block from the header (there are two locking screws on either end of the terminal block).

Connect the wiring for the connected equipment to the terminal block. The back panel of the

enclosure is labeled with the function and polarity or phase indications (See also section 3.2).

Replace the terminal block on the header and tighten the locking screws.

Figure 4.2.1

NCNO

FAULT

COMMON

FAULT

CNCNO

24V

12V

BAT

DC Power Supply

Configure internal jumpers prior to use

See Instruction Manual 52-XXX

OUT8 OUT7 OUT6 OUT5

OUT4

OUT3

OUT2

OUT1

Remove load or reset main power to restore PTC protected zones

For fused units remove front panel to replace fuse.

On other than ‘F’ series units, OUT1 thru OUT8 are Class 2 Power Limited

AC POWER

OFF

RESET

Rear Panel

OUT32 OUT31 OUT30 OUT29 OUT28 OUT27 OUT26 OUT25

Remove load or reset main power to restore PTC protected zones

For fused units remove front panel to replace fuse.

On other than ‘F’ series units, OUT17 thru OUT32 are Class 2 Power Limited

OUT24 OUT23 OUT22 OUT21 OUT20 OUT19 OUT18 OUT17

AC Power Supply

Configure internal jumpers prior to use

See Instruction Manual 52-XXX

12V

BULK

OUTPUT

24V

BULK

OUTPUT

BATTERY

CONNECT

AC FAULT

OUTPUT

COMMON

FAULT OUTPUT

DISTRIBUTED

OUTPUTS

DISTRIBUTED

OUTPUTS

RMMV Series Installation Instructions

7/13/2009, 10:26:56 AM

52-391 Rev A.02

Page 10 of 20

AlarmSaf

65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Alarm SAF RMBE Series Manuel d'instructions Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Enveloppes électriques Alarm SAF RMBE Series